FORTEZA NON-SE non-sensitive element
FORTEZA NON-SE non-sensitive element - Image 2
FORTEZA NON-SE non-sensitive element - Image 3
FORTEZA NON-SE non-sensitive element - Image 4

FORTEZA NON-SE non-sensitive element

1,76 €incl. VAT

The NON-SE non-sensitive element is part of the TRIBO-S (and TRIBO-U underground system) fence protection system, which does not react to deformation or vibration.

Out of stock

SKU: TRIBO-NON-SE
Category: ,

Description

FORTEZA non-sensitive element (NON-SE)

Non-sensitive elements (NON-SE) are designed for:

  • connecting the TRIBO-S (or TRIBO-U) signal processing unit to a sensitive element;

  • passing through gates or buildings along the fence line.

Purpose

The non-sensitive element is part of the TRIBO-S (and TRIBO-U underground system) fence protection system, which does not react to deformation or vibration.
It is used to transmit signals between the TRIBO-S (or TRIBO-U) device and the sensitive element, or to connect two SE-86 sensitive elements using connection sleeves.

General information

  • The maximum length of the non-sensitive element in one TRIBO-S input channel is 300 meters (up to 500 meters for the TRIBO-U system).

  • The sequence SE-86 → NON-SE → SE-86 can be used in the system according to installation needs.

  • The insulation of the non-sensitive element is not weatherproof; therefore, it must be protected with a plastic conduit (corrugated pipe) when installed on a fence or underground.

Installing the non-sensitive element

If the TRIBO-S system needs to provide alarms for different detection zone lengths, the detection zone length can be set between 1–300 meters.

Example:
If the requirement is for the system to provide an alarm for a 50-meter detection zone (2 rows of sensitive elements, which is standard for a 2-meter high fence), the zones are connected according to this requirement.

This installation is also suitable for situations where the TRIBO-S system is integrated with a CCTV (video surveillance) system, so that each 50-meter zone triggers a separate alarm.

Using the non-sensitive element for passing through gates and buildings

If there are gates or buildings within the detection zone, a connection sleeve and a non-sensitive element are used to create non-detecting sections (i.e., zones that do not trigger an alarm).

Installation example:

  1. Connect the SE-86 sensitive element to the NON-SE cable using a connection sleeve.

  2. Install the NON-SE element in a protective conduit and pass it under the gate driveway or building.

  3. After the passage, reconnect the NON-SE to the SE-86 cable using a connection sleeve.

  4. Maintain the same detection zone before and after the gate.

For gate protection, it is recommended to use FMC 10 (50) or FMC 24 Pro (50) devices.

Link to the manufacturer’s website: Tribo NON-SE

Related products